Broken One Piece! What should I do?

[TheLadFisherman]

Hey guys been awhile since I have been on here and I was just looking through some of my old gear and I found my black label technical series and I was wondering if I could do anything about it? It's a 6ft1" rod and its snapped at the middle of the rod. I was think of making it too piece but how do I do that?
Cheers Micah

[little_ash_25]

I think just buy new one or good 2nd hand

[CJ BRIBIE]

I've heard that sort of work can be quite expensive, usually requiring a. Jain rod builder or repairer. Might be worth getting a new rod

[TheLadFisherman]

Originally Posted by CJ BRIBIE

I've heard that sort of work can be quite expensive, usually requiring a. Jain rod builder or repairer. Might be worth getting a new rod

Cheers mate, probs just going to buy a new rod

[Bronco T]

Get a new rod mate there's not much you can do, if you try a get someone to put a Ferrell in a one piece rod it will end up with a dead spot where the Ferrell was placed as the blank was not meant to be two piece and it will stuff the whole taper of the rod and it will probably end up costing more than its worth for a crap result .
If it was broken down close to the handle you could get away with it as it wont effect the taper as much.

[redfinfisho]

Sell it cheap to someone looking for parts like guides a set of Fuji Ti SiC's is still worth abit of money to a person building a rod