|
|||||||
| Reels Who’s using what, find out in here. |
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|||||||
| Reels Who’s using what, find out in here. |
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
02-04-2011, 09:50 PM
|
||||
|
||||
|
shimano anti reverse info needed
hey guys i serviced one of dads reels a while ago and long story short, it has no anti reverse.
can anyone here post up a pic of their anti reverse systems without a lid on it?? or any diagrams or anything lol i really feel bad for wrecking it 
__________________
pb bream 41 fork I use nitro vapor 60, shimano sedona 1000, nitro powerbream finesse 7ft, shimano stradic 2500, nitro ultra bream finnesse 6'6", shimano sienna 1000. 
|
|
#2
02-04-2011, 09:54 PM
|
||||
|
||||
|
Hey man, looked it up like you asked me to, this one is for a sedona but all shimano anti reverse should be the same (super stopper 2)
http://2coolfishing.net/ttmbforum/sh....php?p=1568201
__________________
PB bream 38cm TTF Nitro Powerbream 1-3kg and 7 foot of wickedness symetere 2500 4lb stren microfuse Bream are like girls... I put to much effort into chasing them   www.vyak.net- Sheepy
|
|
#3
02-04-2011, 10:00 PM
|
|||
|
|||
|
you drop the anti reverse bearing race into the reel..then on top of that goes the round circle bit that has one tag and the hole in that tag sits over the anti reverse selection shaft that goes through the reel...then on top of that sits the round circle bit that has two tags..inside the bearing sits the round inner cylinder which likely is stainless and on top of that is one fine small thin stainless washer...someone will load a pic im sure...do not grease the anti reverse bearing..some dont even like oil...just put some oil on your fingers and rub your fingers over the inner cylinder then drop that into position...
__________________
Breammaster - A West Australian fishing site to help people into lure fishing no matter what gear you use . Last edited by bender; 02-04-2011 at 10:03 PM.
|
|
#4
02-04-2011, 10:25 PM
|
||||
|
||||
|
thanks guys, i got it sorted now
the washer that goes between the anti reverse and the main shaft was missing but i've taken apart an old reel and used that one cheers, vaporboy 
__________________
pb bream 41 fork I use nitro vapor 60, shimano sedona 1000, nitro powerbream finesse 7ft, shimano stradic 2500, nitro ultra bream finnesse 6'6", shimano sienna 1000.
|
|
#5
02-04-2011, 11:36 PM
|
|||
|
|||
|
just be aware that some of them are actually a shim and therefore come in many sizes..
__________________
Breammaster - A West Australian fishing site to help people into lure fishing no matter what gear you use .
|
|
#6
02-04-2011, 11:40 PM
|
|||
|
|||
|
__________________
Breammaster - A West Australian fishing site to help people into lure fishing no matter what gear you use .
|
|
|
|
Linear Mode
