Go Back   Bream Master Forums > Bream Tackle > Reels

Reels Who’s using what, find out in here.



Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 23-01-2018, 08:59 PM
Slazmo's Avatar
Slazmo Slazmo is offline
Blue Lip
 
Join Date: Jan 2015
Location: Gold Coast
Posts: 1,520
Reel service intervals - thoughts.

So saw a video the other day with a prominent person in the game and watched it through, certain things i can agree and certainly disagree on but thats life and thats everyones opinions that they're more than welcome to.

But at the end of the vid the comment goes a little like this "use the reel more and service less and use the reel less and service more".

Now I've heard a lot and not wanting to say I'm right over anyone but to me the comment was certainly a bit awkward - for common sense would dictate the direct opposite.

What I was saying a while back is that the following would make good sense for a range of scenarios.

Tourno fishers - service as frequently / as necessary - due to reels being used near full time off boats and getting the wet on wet treatment more than say a weekend warrior.

Weekend warriors - service as frequently as desired - the harder you fish the harder the reels will work and common sense would sugest that they need some love. These guys fish hard and that shows on their gear so anything from 6 / 12 monthly or if it gets dunked etc.

Occasional fisho's - like myself in the sporadic event after work, light weekend work and spur of the moment you would see the intervals drawn out to 12 months - with own light touch ups along the way.

Seldom fisho's - 12 months or as seen fit - keep the reels moving and self touch ups as required.

Now doing touch ups I would say helps prolong a service interval for bearings especially the LRB. Some like in the newer range of Shimano's where no service port exists a screw removed and exposing the bearing to get to its face with a pinpoint oiler is absolutely best along with other bearings around the reel. Aling with that adding oil to the shaft and any shaft / pinion bearing is a must to allowing some form of wear resistance between those applicable parts.

Grease and oils are consumable and definitely a expendable thing in a reel, they do wear out and should be replaced, they can be added to as the old grease from the main and pinion is usually 'thrown / shorn" off the gears from pressure or an accumulation of speed and pressure during fishing itself - and worse when reels are heated in the direct sunlight (radiant heat) where greases start to soften and oils can flash off & it all starts to go bad for the gearbox.

In some exceptional circumstances grease on the main and pinion becomes metallic where the lesser grade / strong (usually aluminium) drive gear wears against the pinion and the grease traps the worn metallic fragments and it will just promote further wear - funily enough the reel remains smooth while this cutting compound of sorts just keeps grinding away at both surfaces. This usually meaning a heart transplant or the reel in time of the main and pinion gearing and if bad enough the idler gears too for oscillation as its all worn relatively over the lifetime.

Its all strange at the moment with thoughts and "trends" & FB followings usually disputes erupt into arguments just because of 'loyalties'. What i want to do is discuss this and not get to any arguments or promote anything and no malicious thoughts intended on any party.
__________________
Find me in the real world...

Last edited by Slazmo; 23-01-2018 at 11:15 PM.
Reply With Quote
  #2  
Old 24-01-2018, 12:00 AM
Stik's Avatar
Stik Stik is offline
Mature Bream
 
Join Date: Apr 2010
Location: South Yunderup
Posts: 451
Also depends who services your reel, they might come back worse than before the service.
I use to get John Devitt to service my overheads but have never had my spinning reels serviced and they seem as good as the day I bought them.
Reply With Quote
  #3  
Old 24-01-2018, 12:08 AM
Slazmo's Avatar
Slazmo Slazmo is offline
Blue Lip
 
Join Date: Jan 2015
Location: Gold Coast
Posts: 1,520
The before and after servicing thing is hard - its a big disruption to the whole mechanical set place of the parts - when they go back even on perfect "same" set place the reel may need time to settle and work back in.

Just my thoughts on that. Its a hard thing - some people dont service because it feels fine yet inside is putrid - that grease has lost most / if not all lubricity and turn into a cutting paste as mentioned above.
__________________
Find me in the real world...
Reply With Quote
  #4  
Old 24-01-2018, 12:12 AM
sevric's Avatar
sevric sevric is offline
Mature Bream
 
Join Date: Jul 2014
Location: Port Macquarie
Posts: 138
Have to agree with your thoughts on reel service. I fall into a category of a 12 month service whether the reel needs it or not. The wife and i have 30 odd reels between us of different brands, sizes and ages. I do the majority of these myself as the cost of postage and service for so many is prohibitive. Add to that the service and parts supply from the two big players is disappointing to say the least. Although i am no slazmo inside a reel the basics can be achieved by almost anyone who is prepared to research, learn and be patient.
Our reels are split 50/50 Daiwa and Shimano. I find Shimano easier to service and our Daiwa stable of reels more long lived seemingly needing service less often. None the less they all get a 12 month overhaul .
__________________
Regards to all Dick
Reply With Quote
  #5  
Old 24-01-2018, 02:48 AM
XeroTAO's Avatar
XeroTAO XeroTAO is offline
Poddy Bream
 
Join Date: Sep 2012
Location: Sydney
Posts: 53
I service my own reels, and usually when i feel like it. Even service when they dont need to, just to keep myself busy. But id say about a yearly rate.

Unless one of my reels gets dunked in water or sand. Then it would get done asap
__________________
If I had a Zerba, I would name him Spot
Reply With Quote
  #6  
Old 24-01-2018, 04:03 AM
Rayman's Avatar
Rayman Rayman is offline
Blue Lip
 
Join Date: Dec 2002
Location: Brisbane, Qld
Posts: 1,070
Used to do it for something to do, but now i go by if it aint broke.

If it starts to feel dry, oil the bearings and new grease on the gears. Drop of oil down the main shaft and line roller every couple of trips..Gone are the days of complete strip downs and clean.. Fishing freshwater mostly so don't feel too bad, and whilst i fish most weekends, have a few reels that get used on rotation so hours per year are probably not a lot.

But yet, definitely would service after a light dunk, even in freshwater. If nothing else, open the reel so that it dries quicker.
__________________
Raymond Y

All the gear, no idea
Reply With Quote
  #7  
Old 24-01-2018, 04:17 AM
yellow door 1's Avatar
yellow door 1 yellow door 1 is offline
Honker
 
Join Date: Jan 2004
Location: melbourne
Posts: 11,527
I'll give my LRB's and other easy to access bearings a squirt every now and then - but apart from that - I wait till I hear something wrong - then get on Breammaster and ask how to fix it
Reply With Quote
  #8  
Old 01-02-2018, 04:45 AM
Felofasofa Felofasofa is offline
Fingerling
 
Join Date: Jan 2018
Location: Lismore area
Posts: 10
Servicing

Hi all, first post here. I recently picked up a couple of spin reels from Gumtree - A Daiwa, and a Shimano. Both are cosmetically 9/10. Both spin silky smooth and seem totally issue free. The Daiwa had one previous owner and is relatively new I think. It's a Magseal reel. Never been serviced I'm pretty sure. The Shimano is older and a JDM reel judging from the all Japanese language documentation.

My question is, should I have a peak inside? Should I get them serviced? I'm pretty handy with a screw driver and used to regularly service my old Abu 6000 overhead when I was a Yak fisher. That reel got regular saltwater dunkings, but I found it relatively easy to tear down, clean and lube, and put it back together. It's a pretty simple reel though and is still going strong. These spin reels look quite a bit more complex.

My own fishing habits vary from intense activity to weeks and months of no use. I'm an irregular fisho.
Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On



All times are GMT -4. The time now is 07:58 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.
Google