|
#1
07-02-2012, 03:52 AM
|
||||
|
||||
|
alphas Type R
I have just picked up a Alphas Type R in top condition and I want to load it up with some braid ,I was just wondering how to load the braid on,I have only had baitcasters with a parallel spool and not a tapered spool. Do I still load with some mono for backing or can I tie the braid to one of the small holes in the
tapered spool?I am going to use a 150m spool of TD Sensor and any ideas if this will fill the spool with out any backing? 
|
|
#2
07-02-2012, 04:04 AM
|
||||
|
||||
|
__________________
 Not associated with any one or any company. I use what I like and give praise where and when praise in due.
|
|
#4
07-02-2012, 06:10 AM
|
||||
|
||||
|
If you want to tie directly to the spool, give the spool a few wraps of plumber's tape. It'll also keep any water from 'filtering' down the spool into the spool bearing.
Otherwise, a metre (or more) of cheap mono backing will do. You might have to put more if the 150m of braid doesn't fill the spool 100%. Really no diff to how you'd fill up a flat bottom spool.
__________________
Raymond Y All the gear, no idea
|
 |
|
|
Linear Mode
