|
Campers, Tents and More Brands, styles what do you want to make your home away from home? |
|
Thread Tools | Rate Thread | Display Modes |
#1
|
||||
|
||||
Knives.
So managed to pick up a Spyderco Salt Rock 'Sprint Run' recently and as per usual over the moon with quality and overall build (even with the high vis orange scalloped handle flanks - opposed to traditional black) of the knife and for $276(AUD) found it to be a steal with the low Aussie dollar overall especially with getting from the USA with their horrendous postage charges - and in comparison to buying the Spyderco Schemmp Rock VG-10 blade for $230(AUD) locally.
I know at one stage after the initial Salt Rock H1's were made obsolete from Spyderco manufacture some of the prices were going 'la la' - some reaching near $800 for BNIB knives... Yes I was near enough dropping the coin on one, until I forgot about it and the 'Sprint Runs' came out again. Spyderco Salt Rock H1 'Sprint Run' - 20160519.jpg Now my question for any of the metallurgical orientated here - I have a nice piece of Ti 6AL4V - which I would like to turn into a overall out doors work blade. Slab of Ti.jpg I have spoken to a company here on the GC that specialises in Laser cutting steel etc, he wont do any cutting due to the refractory blah blah blah something carcenogenic dust - slow death et al effects of it... Spoke to another guy who came recommended that was a an abrasive water cutter who again "I've never cut Titanium" before but we'll give it a go... Its going to be a trial and see what happens kind of scenario - $120 thanks... Any ideas on how to cut it without too much heat build up? Do people have any nice designs that I could turn this into or have a design that would suit this piece of metal? I know I can get some Kydex from the states for a decent sized sheath so thats taken care of. Specs of the Ti are as follows Long: 26cm Wide: 6cm Thick: 3mm
__________________
Find me in the real world... Last edited by Slazmo; 02-06-2016 at 02:07 AM. |
|
|